What type of walls on a deer stand
Contributors to this thread:Whitetail Deer
From: Davy C
25-Aug-16
We have an old deer stand similar to the one in the picture. Steel frame with plywood sides. The plywood is rotting out. I wanted to replace with 1/4" pressure treated plywood but 1/2 " is the thinnest I can find. Any suggestion on what I should use.
From: Scrappy
25-Aug-16
Insulation on the inside with tinn on the outside and roof. Never have to replace again.
From: r-man
25-Aug-16
A good Summit open-shot, be hard getting an arrow shot from one of those
From: drycreek
25-Aug-16
What Scrappy said, and if you want to bowhunt, just cut the windows vertically. I have a round homemade blind with a netting covered window that I have no problem shooting through. It's on ten foot legs.
From: Davy C
25-Aug-16
I already have an open shot thank you. Unfortunately it doesn't climb cattails.
From: XMan
26-Aug-16
Davy, go with 1/4 plywood and just roll it with a few coats of brown oil based paint. it will last you ten years plus and then you can just touch up the rotted areas over time. Plus it will cost $$$ less
From: loprofile
26-Aug-16
I would go with a HEX suit and no walls. Norman