3 Point Disc
Contributors to this thread:Whitetail Deer
From: Bowhuntingboy
18-Apr-17
Hi, we are looking for a 3 pt disc for our 24 hp kubota tractor. We are going to be doing a one acre plot. We would like to pay less than 400 dollars for anything less than 6 ft but greater than tiny. Any reccomendations? Anything other than a tiller that can do the same job as a disc? Thanks
From: drycreek
18-Apr-17
I would think anything more than a 4' disc would be too much for a 24 hp tractor. I use a 6' Land Pride, which is pretty heavy, and I can get in soils that make my 57 hp Kubota spin a wheel occasionally. If you have front wheel assist, you might get by with bigger. Kinda depends on your soils and how deep you want to disc.
From: Bowhuntingboy
18-Apr-17
4 foot is what I would like. Any reccomendations?
From: t-roy
18-Apr-17
Have you checked your local farm supply store? They usually carry what you're looking for. King Kutter and Woods are 2 pretty good brands.
From: Bowhuntingboy
19-Apr-17
Are king kutter available for a 3 pt hitch?
From: wilbur
19-Apr-17
wilbur's Link
Check ebay and craigslist there is a bunch listed.
From: sticksender
19-Apr-17
Back when I used to have only a tiny tractor like that (JD 25 hp) I used a 5-foot JD 3-pt disc. Worked ok, but I had to load it down with weight to get it to bite into the soil at all. Biggest downfall of those small cheap lightweight discs is the lack of sealed bearings. Constantly need to be re-packed with grease and they still wear out fast. The answer, for me, was a bigger tractor, which handles a bigger, better-built disc.
From: Bowhuntingboy
19-Apr-17
Well, it is a diesel tractor with a pto, so it is pretty powerful.
From: drycreek
19-Apr-17
I have a Land Pride. It's pretty heavy-duty, and does a good job. I had two more before that, one used, one new, and they didn't last too long. A good heavy-duty disc should last for years just food plotting.
There are many different brands, Tractor Supply has some mid-weight discs, and tractor dealers usually have discs, but I would peruse the internet and research brands before I bought. Pay attention to weight, if they're too light, they won't last. Good luck !
From: Habitat1
19-Apr-17
It is still low HP,I haven't used my disc in several years.It's either a tiller or no till
From: r-man
19-Apr-17
I plow with a craftsman mower , 26-7hp , 48" , if it was diesel I could pull a lot more. Check out northertool.com
From: flyingbrass
19-Apr-17
4 foot is what I've pulled with my 23hp, another 23 hp and a 28 hp. great fit!
From: fastfoodplots
21-Apr-17
Where are you located? I have a 3 pt. 6ft set of discs I'm looking to get rid of.
From: Bowhuntingboy
21-Apr-17
Not near Pennsylvania