Glue and Bohning Heat vanes ?
Contributors to this thread:General Topic
From: Pope125
04-Jan-18
This morning I was trying to fletch up some arrows , was putting the heat vanes on some wraps . Was wondering what guys are using to clean these vanes . I used 91@ Isopropyl Alcohol to clean the vanes , and used Bohning Fletch-Tite Platinum . After a few hours gave the vanes a tug and they pulled off . What went wrong ??
From: PAbowhunter1064
04-Jan-18
You didn't use Loc-Tite Ultra Control Gel....I use them on my Heat vanes, and have had great results.
From: wildwilderness
05-Jan-18
Bohning does NOT recommend cleaning their vanes. I use NPV cement with good success
From: trkyslr
05-Jan-18
Use aae maxbond... work great with my heat vanes
From: Deone H
06-Jan-18
Don’t clean the vane and use bohning blazer bond. I use heats and this glue and cannot hardly get them back off
From: joehunter8301
07-Jan-18
That glue is junk. Use Maxbond and make sure you spread the glue along the whole rim of the fletch. Don’t jus run a bead an assume it will spread when u press it down. See lots of guys do this. Use a toothpick to spread it then stick it on the arrow