Onieda aeroforce question
Contributors to this thread:Equipment
From: BOX CALL
23-Sep-17
Trying to work a deal for an onieda aeroforce compound.its 50-70# and sets at 29" draw.question is I'm a finger shooter and can this bow go to 31" draw.if not would the 29" draw work with a release.thanks,dan
From: OkieJ
23-Sep-17
Dan, you can get different Modules for the Onieda bows to change DL.
From: Coyote 65
23-Sep-17
Yes you can use a release and that would be about right for one set up for 29. You can also set up stops to fine tune anchor point.
Terry
From: BOX CALL
24-Sep-17
How hard is it to use a release.I've never used one in my life.using fingers since 1973.
From: WV Mountaineer
24-Sep-17
Dan, I grew up shooting trad bows and compounds with fingers. In the mid 90's I went to a release for my compounds. I had quite the time getting used to them. But, at that point in my life, I knew very little about proper compound form either. shooting bows that were way to long and such. I switched back to a compound this year after going trad only for a good while and had zero trouble with it. I don't know if that was due to better form or what. Just give it a try if you decide to and like everything else, stick with it until you get it bud. God Bless.
