Fetching glue?
Contributors to this thread:Equipment
From: Fuzz
14-Aug-18
Any favorites?
And what, if any, do you prep shafts with before fletching? I typically wipe them down with alcohol wipes.
From: LINK
14-Aug-18
I like G5 blue glue for teaching my dog to fetch. It really seams to stick with him. ;)
From: Boatman71
14-Aug-18
gorilla glue ;-)
From: Kodiak
14-Aug-18
Tape.
From: arlone
14-Aug-18
I'm with Kodiak, I use tape on wood finished with gasket lacquer. Never had a problem. YET!
From: grubby
14-Aug-18
gorilla gel directly to bare carbon works for me
From: Fuzz
14-Aug-18
Lol link!...Damn auto correct... I caught it when asking my question but not in the title :-(
Ok thanks for the ideas. I'm gonna try the gorilla.
From: Boatman71
14-Aug-18
LOL I just caught it! Link that made me laugh literally out loud! After I saw it that is.
From: Mark Watkins
14-Aug-18
VaneTec VT 2000 (on VaneTec vanes) on wrapped shafts......It would take a herd of monkeys to tear them off.
Mark
From: stagetek
14-Aug-18
Either Saunders NPV or Fletch-tite.
From: Dale06
14-Aug-18
Platinum fletch tite
From: Buffalo1
14-Aug-18
Bohning Platium Fletch-tite glue
Bohning Platium Fletch-tite glue
My longtime, dependable fletching glue. Works on raw shafts or wraps.
From: Kodiak
14-Aug-18
From: Chaza402
14-Aug-18
AAE-
From: Will
16-Aug-18
100% with Hackbow and the Gorilla Gel. Works fantastically!
From: APauls
17-Aug-18
I don't go through enough arrows. Platinum fletchtite works well when it is fresh, but I have had it go bad on me a few times.
From: Wood
19-Aug-18
Best I've used so far is Loctite super glue professional liquid. I clean shafts with acetone and then denatured alcohol and cote vane bases with Zing primer.
From: Dooner
21-Aug-18
I use Loctite super glue also. If I am remembering correctly, it is hydrophilic and I didn't have great luck with acetone, or alcohol. I just scrub my shafts with hot water and comet, then rinse well, and dry. I don't ever loose fletchings now. I think Big Dan posted this technique years ago. Good Luck Fuzzy. I's hate to see you loose a feather/fletch while shooting your Sitka:-)
From: WapitiBob
21-Aug-18
Mek then dawn dish soap, clean water rinse and paper towel, aae glue with zing accelerator.
From: Bou'bound
21-Aug-18
Loctite here too
From: midwest
21-Aug-18
Zing primer then Loctite Gel Control on wraps.
From: Rut Nut
21-Aug-18
Been using the Platinum Fletch-tite for years.
From: LUNG$HOT
22-Aug-18
Loctite gel control works best for me on bare shafts.
From: darralld
22-Aug-18
Used tape for the first time yesterday. Man I'm never going back to glue again.