Bear skull display?
Contributors to this thread:Bears
From: Brian M.
27-Nov-18
Just got my bear skull back. How are you displaying your skulls? I'm thinking of a Maine State plaque for the wall. Show and tell please.
From: molsonarcher
27-Nov-18
From: molsonarcher
27-Nov-18
Skull hooker trophy tree. Also the wall mount or tabletop skull hooker.
From: Schmitty78
27-Nov-18
I put mine in with a mink I trapped a few years back. Not necessarily what you’re looking for, but I like how it looks anyway:)
From: Bou'bound
27-Nov-18
Put it under glass in a nice quality memoribila football display case.
From: Nick Muche
27-Nov-18
It’s like the shelf was built for them :)
From: Cobie33
27-Nov-18
Table top skull hooker on my desk.
Table top skull hooker on my desk.
From: Cobie33
27-Nov-18
Nothing special plaque on my other.
Nothing special plaque on my other.
From: jstephens61
27-Nov-18
Dang Nick! What have you done with the hides?
From: Elkoholic
27-Nov-18
From: Errorhead
27-Nov-18
Hookers on an old board.
From: TEmbry
28-Nov-18
I have a few bookcases in my office and luckily I don’t own many books :)
From: Brian M.
28-Nov-18
Thanks guys. Nick, I only have one, that shelf would be way too long. Cobie, that "nothing special" plaque is what I was thinking, but in the shape of Maine.
Wen hung, how do you keep the two parts from falling apart?
From: Bou'bound
28-Nov-18
Put it under glass in a nice quality memoribila football display case.
From: molsonarcher
28-Nov-18
OP. I use hot glue at the joint of the jawbone to the skull. Just make sure both surfaces are clean and dry. Some guys use screws or wire. I like the hot glue as it isnt seen, and is still removable fairly easily.
From: Cobie33
28-Nov-18
Like molsonarcher said, used hot glue on the joint between the lower jaw and the skull. That skull is then screwed to the plaque with two screws that you can only see directly from behind. Did the same with the glue on the two skulls on the skull hookers.