Summit Treestands
Peep sight question
Equipment
Contributors to this thread:
Bou'bound 17-Sep-19
Whocares 17-Sep-19
pointingdogs 17-Sep-19
SoDakSooner 17-Sep-19
Brotsky 17-Sep-19
Grey Ghost 17-Sep-19
Trial153 17-Sep-19
midwest 17-Sep-19
wyobullshooter 17-Sep-19
Scoot 17-Sep-19
12yards 17-Sep-19
stick n string 17-Sep-19
Boatman71 17-Sep-19
sdkhunter 17-Sep-19
Rut Nut 17-Sep-19
Ucsdryder 17-Sep-19
Boreal 17-Sep-19
lewis 17-Sep-19
ARROWONEPY 17-Sep-19
Scooby-doo 17-Sep-19
Bowfreak 17-Sep-19
From: Bou'bound
17-Sep-19
What brand and size peep sight are you runnin’

From: Whocares
17-Sep-19
A round black one of the little larger size. That's all I know and hope it helps!

From: pointingdogs
17-Sep-19
Same as Whocares. The bigger peep lets these old eyes see better in low light.

From: SoDakSooner
17-Sep-19
Specialty archery. No insert. It allows you to fine tune the peep and use clarifiers and rectifiers as well. Has a super large aperature without any kind of insert. IMO the Cadillac of peeps.

From: Brotsky
17-Sep-19
RAD Super Deuce 38 on all of our bows. Size varies depending upon string angle, draw length, and sight housing size. I like the peep to just barely outline the sight housing. Great peeps.

From: Grey Ghost
17-Sep-19
I match my peep size to allow me to see the whole diameter of my sight (about a 3/16” hole). This gives an easy reference for shot alignment, and provides an adequate FOV thru the peep.

Matt

From: Trial153
17-Sep-19
I use two different peeps depending on what I set the bow up to hunt.

The peep I use the most is a 1/4 Hot Shot accue peep. I also like the Viper peep in 3/16

From: midwest
17-Sep-19
Good ol' Fletcher Tru-Peep. 3/16" diameter lines up perfect with my MBG sight housing.

17-Sep-19
1/4” Tru-Peep.

From: Scoot
17-Sep-19
13/79"

From: 12yards
17-Sep-19
1/4" RAD in one bow, 1/4" G5 Meta Peep in two other bows.

17-Sep-19
Awful personal. Next thing you’re going to want are the coordinates next to my best hunting spot. No thanks

From: Boatman71
17-Sep-19
Podium Peep on my target bow, a big round one on my hunting bow :-)

From: sdkhunter
17-Sep-19
RAD 3/16

For me the 1/4 has too much open area around my sight housing...

From: Rut Nut
17-Sep-19
Ask Jay Fuller................................... ;-)

From: Ucsdryder
17-Sep-19
Rad as well. Whatever size needed to fit my sight housing.

From: Boreal
17-Sep-19
Verifier XL

From: lewis
17-Sep-19
I’m using one this year with a post in it with a single pin so far I like.We shall see.Good luck Lewis

From: ARROWONEPY
17-Sep-19
3/16 tru peep

From: Scooby-doo
17-Sep-19
G5 1/4". My eye is good at centering the pin and I like the added light it lets in when the light is fading fast. Shawn

From: Bowfreak
17-Sep-19
3/16" Hot Shot

  • Sitka Gear