New Iron Will Single Bevel BroadheadsContributors to this thread:
Bill V - Iron Will 19-Jan-21
Bill V - Iron Will 's Link
We’ve had a lot of request for single bevels for a couple of years now. I've often said that a double bevel gives you a better combination of sharpness, edge retention and durability. This is inherent in the geometry and I have not changed my mind on this. It took a while to get a single bevel edge geometry that I was willing to stand behind with a lifetime warranty. The rotation of single bevels has been intriguing though. The theory here is that the pressure on one side of the blade creates a rotation which causes an S shaped cut through hide and tissue and pops bones further apart as it passes through. After consulting with Dr. Ashby and other single bevel advocates and testing a range of blade angles, we are launching a design that I believe will open up holes and slice more tissue without reducing penetration. Available for pre-order now and we start shipping in early March with and without single bevel bleeders.
Would these be very difficult to resharpen?
Here are my thoughts on the bleeder. To open up holes, I've always preferred our 2-blade with bleeder over a single bevel. Depending on the single bevel design, they can create an S cut which opens up holes better than a 2-blade double bevel with no bleeder, but not quite as well as a 2-blade with 3/4" bleeder in my experience. If you add a bleeder to a single bevel head it will reduce this rotation unless you make a bleeder with a single bevel grind also, which is what we've done. To me this could be the best of both worlds for opening up holes, getting S cuts in two directions as it rotates through. The holes through the hide become more open and circular and more tissue is cut all the way through the animal. I shot a buck a few weeks ago using the single bevel with bleeder and it looked like a faucet was turned on as the buck walked away. I'll post a video of this blood trail sometime. Based on the positive results, we've decided to offer them with and without bleeders [naming conventions is sb125 and sb125buff (no bleeder)].
Midwest, Single Bevels are pretty easy to re-sharpen. Compared to double bevels they are a little faster since you are running the stones on one side only with a single pass on the backside to remove any burr. You could touch up by hand on a fine stone. For thorough re-sharpening, I would remove the blades and use a knife sharpening kit using flat stones where you can set the angle like a KME. I was doing this yesterday and it only took a couple minutes per edge.
Bill V - Iron Will 's Link
Great testing video from Lusk Archery Adventures. Thanks for testing John!
Very nice! I’m a fan of single bevel broadheads. If I could afford these heads I would definitely shoot them. I blew through the thick part of an elk shoulder blade and exiting the opposite side just above the brisket bone. Massive damage and it definitely rotated.
Iron Will has a winner on this one from my point of view. FYI, a single bevel broadhead is not hard to sharpen with the correct tools. Good job Iron Will.
This looks like a great head, Bill. I see that the rear edge is also single bevel on the same plane as the cutting edge. Is this a factor of geometry, or just for sharpening simplicity? Great job again!
Pretty cool man!!!
Bill puts 100% into his designs. Nice work
Very interested now!
Hey Lou, I didn't want a squared off back edge. Fluid dynamic modeling shows this would create more turbulence and noise compared to a taped back edge. I also wanted the back edge to be sharp. Continuing the single bevel around the back edge created the best geometry for this. We are getting some great test results that I'll share here soon.
Bill, I can't wait for the test results to come out . These heads look awesome and with the single bevel they should be easy to resharpen.